Construction/Exterior
Two-piece seamless construction featuring a Buddy Davis™       hull with solid fiberglass bottom, Divinycell®       cored hull sides, a one-piece reinforced fiberglass       super structure with foredeck, cabin and bridge       with a one-piece fiberglass reinforced cockpit.
Lower guardrails and upper shear guards are       fiberglass with stainless steel rubrail protective       molding.
All exterior cleats are reinforced with heavy-duty       metal backing plates.
All underwater appendages are bonded and main       struts are reinforced with heavy-duty backing       plates
Non-skid on foredeck

Hardware And Outfitting
Stainless steel cleats--(2) stern, (2) amidship, (2)      forward
Stainless steel water-fill deck plate mounted on      foredeck
Stainless steel line chocks (2)
Stainless steel 1" rubrail/molding on sheer and      guards
Buddy Davis™ Custom stainless steel transom corner      hawse pipes
Teak bow pulpit
Teak toerail
Hinged, gasketed fiberglass, bow deck anchor
     locker
Three Bomar® hatches

Mechanical
Emergency bilge pump system
Emergency "Y" valve feature on engine sea
     Strainer inlet
Quater-turn sea valves on all bottom
     thru-hull fittings
12-gallon water heater
Fiberglass silencers
10 KW Westerbeke® diesel generator with
     sound shield
High-amperage marine engine alternators
Engine room vent fans
DC oil change system
Stainless steel shafting, Aqua Met®-22 HS
Automatic fresh water system with pump
Water filtration system
Nibral propellers, ISO Class 1
Waste holding tank system with pump-out
Automatic shower sump pump-out
Main engine start and stop switches
Buddy Davis™ Custom rudders - stainless steel
Port and starboard centralized drainage system
Fuel filters for main propulsion and generator
Coolant recovery system on main propulsion engines Stainless steel trim tabs with recessed actuators Engine room faired and painted with high gloss      Awlcraft®2000 paint
Dripless shaft and rudder seals

Electrical
120/240-volt 50-amp shoreline
Custom AC/DC main electrical panel with amperage      and voltage metering, sliding gate shore/generator      selector system, magnetic circuit breakers,      generator remote and bilge pump control
Two deep-cycle banks maintained by a fully      automatic battery charger
Battery parallel system
AC and DC fluorescent engine room lighting with      duplex ground fault receptacle
Fresh water and fuel tank level gauges
Internal bonding system with zinc anode protection
AC and DC lighting in staterooms and salon/galley Ground fault protected utility receptacles throughout CA/TV-Phone inlet

Command Bridge Deck
Buddy Davis™ Custom teak helm bubble with single-lever
     controls, polished stainless steel control handles      and steering wheel, neutral lockout and engine      synchronizer
Sliding aluminum door with tinted plexiglass insert
Buddy Davis™ Custom aluminum grab rails
Fuel gauge
Wrap-around seating with vinyl cushions and storage      underneath - hinged with gas shocks
Large electronics console with clear plexiglass      weather shield
Large port and starboard storage compartments      under helm deck
Compass with light
Helm chair
Engine gauge package

Cockpit
Baitwell - large circular and insulated with seawater      circulation pump
Insulated drink box with removable tray
Large insulated under-deck fishbox with macerator      pump-out
Large, removable under-deck dunnage box
Hot/cold cockpit shower
Walk-through tuna door with locking latch
Teak cover boards
Engine room entrance, hinged with gas shocks, with      self-draining waterways
Buddy Davis™ Custom drain scuppers - stainless steel
Dockside water inlet with pressure-reducing valve Built-in backing plate for fighting chair
Fresh and saltwater wash down systems with quick      disconnects
Top-loading freezer with removable bait tray
Built-in oversized tackle centers (2)

    <<Previous     Next>>

back to top