Hardware And Outfitting
Stainless steel 12" cleats--(2) stern, (4) amidship,
      (2) forward
Stainless steel water-fill deck plate mounted in      cockpit for easy access
Stainless steel line deck pipe
Stainless steel line chocks (2)
Stainless steel 1" rubrail/molding on sheer and      guards
Buddy Davis™ Custom stainless steel transom corner      hawse pipes
Teak toerail with bow pulpit
White side-mount cabin handrails

Mechanical
Emergency bilge pump system
Quarter-turn sea valves on all bottom thru-hull fittings Stainless steel 20-gallon water heater
Fiberglass silencers
15 KW diesel generator with sound shield
Engine room vent fans
DC oil change system
2-1/2" stainless steel shafting, Aqua Tech-22
Automatic fresh water system with pump
Nibral propellers, Class S
Waste holding tank system with pump-out
Automatic shower pump-out
Main engine start and stop switches
Buddy Davis™ Custom stainless steel rudders
Engine room freshwater outlet
Port and starboard centralized drainage system
Fuel filters for main propulsion/generator engines Coolant recovery system on main propulsion engines Stainless steel trim tabs with recessed actuators
High Gloss Awlcraft®2000 engine room paint finish Water filtration system
Dripless shaft and rudder seals

Construction/Exterior
     Two-piece seamless construction featuring a Buddy Davis™ split hull mold with solid fiberglass bottom, Divinycell® cored fiberglass hull sides a one-piece reinforced fiberglass super structure with foredeck, cabin and bridge and a one-piece fiberglass reinforced cockpit. All exterior above water-line finishes areAwlcraft®2000. Below waterline finish is epoxy blister protect sealant with Awlstar® bottom coat. Lazarette and engine room are faired and top-coated with Awlcraft®2000 white paint. Salon deck, forward cabin deck and cockpit deck are reinforced with Nydacore® vacuum bag construction. Main interior bulkheads are lightweight Nydacore® with solid fiberglass reinforcement to structural bonding surfaces.Lower guardrails and upper shear guards are solid fiberglass with stainless steel rubrail protective molding.
     All exterior cleats are reinforced with solid metal backing plates.
      All underwater appendages are bonded and main struts are reinforced with fiberglass and bronze backing plates.

Flybridge
DC electrical panel with circuit breakers
Buddy Davis™ Custom teak helm bubble with single-lever      controls, polished stainless steel control handles      and steering wheel, neutral lockout and engine
     synchronizer
Electrically activated lift-up electronics console
Fuel gauge
Wrap-around seating with storage under and
     all-weather cushions
Ritchie compass with light
Helm chairs (2)
Insulated drink box
Molded armrest with storage
Anodized aluminum ladder secured/fitted to cabin top

Cockpit
Baitwell - circular, lighted, and insulated with      seawater circulation pump
Insulated drink box with removable tray
Large insulated under-deck fish box with pump-out Built-in insulated transom fish box
Large, removable under-deck line and fender storage Hot/cold cockpit shower
Large walk-through tuna door with locking latch and      heavy-duty stainless steel recessed hinge
Recessed exterior lighting molded in overhang
Teak cover boards
Engine room entrance with draining waterways
High volume overboard drains
Dockside water inlet with pressure- reducing valve Built-in backing plate for fighting chair
Fresh and saltwater wash down systems with quick      disconnects
Top-loading freezer with removable bait tray
Tackle center
Cable rewind

Electrical
120/240-volt 50-amp retractable shoreline with cable      storage
AC/DC main electrical panel with amperage and      voltage metering, sliding gate shore/generator
     selector system, magnetic circuit breakers,      generator remote and bilge pump control
24/12-volt flybridge electrical panel for equipment
     and electronics
Four heavy-duty marine 12-volt batteries grouped in      two 24-volt banks maintained by a fully automatic      battery charger
Battery parallel system
AC and DC fluorescent engine room lighting with      duplex ground fault receptacle
Fresh water and fuel tank level gauges
Internal bonding system with zinc anode protection      and Dynaplate™ grounding
AC and DC lighting in stateroomsand salon/galley Ground fault protected utility receptacles throughout CA/TV-Phone inlet

Safety And Navigation
Navigation lights
Automatic bilge pumps in lazarette, engine room
     and forward bilge with high-water alarm
Alarm system for engine and gear oil pressure, water temperature and exhaust system
Automatic engine room fire suppression system Smoke/fire alarm system

 <<Previous     Next>>

back to top