|
Construction/Exterior
Three-piece
seamless construction featuring a Buddy Davis
hull with solid fiberglass bottom, Divinycell®
fiberglass core hull sides, a one-piece reinforced
fiberglass super structure with foredeck,
cabin and flybridge and a one-piece fiberglass
reinforced cockpit.
All exterior above water-line finishes are Awlcraft®2000.
Below waterline finish is epoxy blister
protected with Awlgrip® antifouling bottom coat.
Forward machine tunnel and lazarette are faired and top-coated
with Awlcraft®2000 white paint. Salon deck,
forward cabin deck and cockpit deck are reinforced
with Nydacore® vacuum bag construction.
Lower guardrails and upper shear guards are fiberglass
with stainless steel rubrail protective molding.
All exterior cleats are reinforced with heavy-duty metal
backing plates.
All underwater appendages are bonded and main struts
are reinforced with heavy-duty backing plates.
Mechanical
Emergency
bilge pump system
Emergency "Y" valve feature on engine sea strainer inlet
Quarter-turn sea valves on all bottom thru-hull fittings 20-gallon
water heater
Fiberglass silencers
25 KW Westerbeke® generator with sound shield
High-amp marine engine alternators
Engine room vent fans
DC oil change system
Stainless steel shafting, AquaMet® -22 HS
Automatic fresh water system with pump
Nibral propellers, ISO Class 1
Waste holding tank system with pump-out
Automatic shower sump pump-out
Main engine start and stop switches
Buddy Davis Custom rudders - stainless steel
Port and starboard centralized drainage system
AC and DC fuel transfer pumps
Engine room freshwater outlet
Buddy Davis Custom sea chest with strainer plates
Fuel filters for main propulsion/generator engines
Walk-in engine room entry
Coolant recovery system on main propulsion engines Stainless steel
trim tabs with recessed actuators
Engine room faired and painted with AWLCRAFT®2000
Dripless shaft and rudder seals
Power assisted steering
Hardware
And Outfitting
Stainless
steel cleats - (2) stern, (4) amidship,
(2) forward
Stainless steel water-fill deck plate mounted in cockpit
for easy access
Stainless steel line chocks (2)
Stainless steel 1"rubrail/molding on sheer
and guards
Buddy Davis Custom stainless steel transom corner hawse
pipes
Teak toerail
Teak bow pulpit
Powder-coated, white side-mount cabin handrails
Hinged, gasketed fiberglass, bow deck anchor locker hatch
Three Bomar® hatches w/sun shades
Electrical
2
each 120/240-volt 50-amp Glendinning®
2 each 50-amp shoreline isolation transformers
AC/DC main electrical panel with amperage and voltage
metering, sliding gate shore/generator selector
system, magnetic circuit breakers, generator
remote and bilge pump control
24/12-volt flybridge electrical panel for equipment and electronics
Four heavy-duty marine 12-volt batteries grouped in two
24-volt banks maintained by a fully automatic
battery chargers
Battery parallel system
AC and DC fluorescent engine room lighting with duplex
ground fault receptacle
Fresh water and fuel tank level gauges
Internal bonding system with zinc anode protection
AC and DC lighting in staterooms and salon/galley Ground fault protected
utility receptacles throughout CA/TV-Phone inlet
Flybridge
DC
electrical panel with circuit breakers
Buddy Davis Custom teak helm bubble with single-lever controls,
polished stainless steel control handles and
steering wheel, neutral lockout and engine
synchronizer
Electrically activated lift-up electronics console Insulated drink
box/storage box under forward flybridge
seating
Fuel gauge
Wrap-around seating with rod storage under and
vinyl cushions
Compass with light
Helm seat and companion seat
Large insulated drink box
Engine gauge package
Buddy Davis Custom aluminum grab rails
Cockpit
High capacity baitwell - circular and insulated with seawater
circulation pump
Insulated drink box with removable tray
Large insulated under-deck fish box with macerator pump-out
Built-in insulated transom fish box
Large, removable under-deck dunnage box
Hot/cold cockpit shower
Large walk-through tuna door with locking latch
Exterior lighting molded in overhang
Teak cover boards
Engine room entrance with self-draining waterways
Buddy Davis Custom drain scuppers - stainless steel
Dockside water inlet with pressure- reducing valve Fresh and saltwater
wash down systems with quick disconnects
Built-in heavy-duty backing plate for fighting chair
Top-loading freezer with removable bait tray
Built-in extra large tackle center
Salon
Stainless
steel threshold at salon door
Carpeting with sound insulating carpet pad
Vinyl headliner
AC and DC light fixtures
Wood accent package
AC duplex outlets
Sofa with pneumatic lifting seats to access storage beneath
Solid wood valance with window shades
Upholstered lambrequin boards
CD/stereo sound system with flat screen television and
DVD player
Bose® sound system
Icemaker
Wine captain
Air-conditioning system (32,000 BTU) with digital control
Tinted and tempered window glass
Telephone/modem outlet
High capacity overhead rod storage - port and starboard
Cocktail table
Throw pillows
Dinette
Area
Upholstered
dinette seating area
Storage under cushions
Dinette table
Lighting
Galley
SubZero®
under-counter refrigerator and
under-counter freezer with veneer
faces
Convection/microwave oven
Stainless steel sink with faucet
Ceramic 4-burner cooktop
Exhaust fan
Storage cabinets and drawers
Corian® countertops
Amtico® teak and holly flooring
Wood accent package
Over-counter lighting
Pull-out trash bin
<<Previous Next>>
back to top
|